D-Zolve 15-33R Aircraft Stripper D-Zolve™ 15-33R is a brush-on or spray-on stripper which removes Powder Coating, E-Coating and paint. High viscosity properties enable it to cling to vertical surfaces. D-Zolve 15-33R conforms to Boeing DG-1748 M and is approved for the use by the U.S. Air Force.
It removes aircraft paints which include epoxy primer and cross-linked polyurethane including Mil P 23377 epoxy or TTP 2760 flexible polyurethane and Mil C85285 polyurethane topcoat, fluid resistant BMS 10-60-H, BMS 10-7-9 and Desothane 62217 as well as top coats with high solid topcoats with high solid content fluoride. D-Zolve 15-33R can be safely used with Aluminum, Magnesium, Stainless Steel, Carbon Steel, Cadmium Coated Steel and Titanium. It contains no chlorinated components, no peroxides and is non acidic and non-flammable. It’s very slow to evaporate and with a vapor pressure below 0.07 is technically a non-VOC.
Best results are obtained at ambient temperature above 76°F/24°C.
D-Zolve 15-33 Immersion Aircraft Paint Stripper D-Zolve™ 15-33 IM is an immersion grade paint stripper used in a dip tank heated to 135°F/57°C. It meets the chemical requirements for safely removing coatings from aircraft wheels, landing gear components and other support equipment parts. Immersing parts in D-Zolve removes several layers of a difficult to strip epoxy, flexible polyurethane, polyurethane topcoat or fluid resistant coating. D-Zolve 15-33 IM fully conforms to T.O. 1-1-8 and meets the specifications set by USAF Mil PRF.83936C. It has passed the corrosion, flammability, hydrogen non-embrittlement and paint removal performance standards set by this specification. D-Zolve 15-33 IM is suitable for use with aluminum, magnesium, cadmium plated steel and other ferrous and non-ferrous metals. Designed to minimize health and environmental risks, it has no chlorinated components, is non-acidic as well as non-carcinogenic and features a long active life and slow rate of evaporation.